PLC-RS…/21
Accessories
Description
Insulating plate
Type
PLC-ATP BK
Order No.
2966841
Pcs./Pck.
25
The PLC-ATP BK insulating plate should be used in the following cases: always fit at the start and end of a PLC terminal strip for voltages
greater than 250 V (L1, L2, L3) between the same terminal points on adjacent modules (FBST 8-PLC... or FBST 500... can be used for
potential bridging) and for safe isolation between adjacent modules.
For additional accessories such as power terminal blocks and plug-in bridges, please refer to the INTERFACE catalog or www.phoenixcontact.com .
3
Technical Data
Input Data
Nominal input voltage 1
...24DC...
24 V DC
...24UC...
24 V AC/DC
...120UC...
120 V AC/
...230UC...
230 V AC/
110 V DC
220 V DC
Permissible range (with reference to U N )
Typical input current at U N
Typical response time at U N
Typical release time at U N
9 mA
4 ms
8 ms
11 mA/8.5 mA
6 ms
15 ms
3.5 mA/3 mA
6 ms
15 ms
3 mA
7 ms
15 ms
Input circuit
Yellow LED,
protection
against polarity
reversal, free-
wheeling diode
Yellow LED, bridge rectifier
1
The PLC-ATP BK insulating plate must be installed for voltages greater than 250 V (L1, L2, L3) between the same terminal points on adjacent modules
(see "Accessories"). FBST 8-PLC... or FBST 500... is then used for potential bridging.
Output Data
Contact type
PLC-...21
Single contact, SPDT
PLC-...21AU
Contact material
Maximum switching voltage
Minimum switching voltage
Limiting continuous current
Maximum inrush current
Minimum switching current
Maximum shutdown power
Minimum switching power
24 V DC
48 V DC
60 V DC
110 V DC
220 V DC
250 V AC
AgSnO
250 V AC/DC 2
12 V AC/DC
6A
30 A (for AC 15 operation)
10 mA
Ohmic load τ = 0 ms
140 W
20 W
18 W
23 W
40 W
1500 VA
120 mW
AgSnO + 5 μ A 1
30 V AC/36 V DC
100 mV
50 mA
50 mA
1 mA
Ohmic load τ = 0 ms
1.2 W
10 μ W
1
2
If the specified maximum values are exceeded, the gold coating will be damaged. In subsequent operation, the AgSnO contact values given here will
apply . This can then result in reduced service life, similar to dedicated power contacts.
The PLC-ATP BK insulating plate must be installed for voltages greater than 250 V (L1, L2, L3) between the same terminal points on adjacent modules
(see "Accessories"). FBST 8-PLC... or FBST 500... is then used for potential bridging.
General Data
Impulse voltage withstand level
Ambient temperature range
Operation
Storage/transport
Nominal operating mode
Inflammability class according to UL 94 (housing)
Mechanical service life
4 kV, 50 Hz, 1 min.
-25°C ... 60°C (230 V type -25°C ... 55°C)
-40°C ... 85°C
100% operating factor
V0
2 x 10 7 cycles
101780_en_02
PHOENIX CONTACT
3
相关PDF资料
2967617 RELAY GEN PURPOSE SPDT 10A 12V
2982236 RELAY GEN PURPOSE SPST 6A 24V
2POSTRMKITWM KIT BRACKET WALLMOUNT FOR UPS
3-1393223-8 RELAY GEN PURPOSE SPDT 8A 48V
3-1393236-0 RELAY GEN PURPOSE SPDT 6A 24V
3-1393278-7 RELAY AUTOMOTIVE SPDT 45A 24V
3-1393774-4 RELAY GENERAL PURPOSE SPDT 1A 5V
3-1393779-7 RELAY GEN PURPOSE SPDT 3A 24V
相关代理商/技术参数
2966498 功能描述:工业继电器 PLC-RSP- 48DC/21 RoHS:否 制造商:TE Connectivity / Kilovac 触点形式:1 Form A (SPST-NO) 触点电流额定值: 线圈电压:9 VDC to 36 VDC 线圈电阻:38 Ohms 线圈电流: 切换电压: 安装风格:Panel 触点材料:Silver Palladium
2966508 功能描述:DIN导轨式接线端子 PLC-ESK GY RoHS:否 制造商:Phoenix Contact 类型:Feed Through Modular Terminal Block 位置/触点数量:1 线规量程:26-14 电流额定值:5 A, 15 A 电压额定值:300 V, 600 V 安装风格: 端接类型:Push-In
2-966509-9 制造商:TE CONNECTIVITY 功能描述:TSP MT BU-GEH 16P
2966511 功能描述:工业继电器 PLC-RSP- 60DC/21 RoHS:否 制造商:TE Connectivity / Kilovac 触点形式:1 Form A (SPST-NO) 触点电流额定值: 线圈电压:9 VDC to 36 VDC 线圈电阻:38 Ohms 线圈电流: 切换电压: 安装风格:Panel 触点材料:Silver Palladium
2966524 功能描述:工业继电器 PLC-RSP-120UC/21 RoHS:否 制造商:TE Connectivity / Kilovac 触点形式:1 Form A (SPST-NO) 触点电流额定值: 线圈电压:9 VDC to 36 VDC 线圈电阻:38 Ohms 线圈电流: 切换电压: 安装风格:Panel 触点材料:Silver Palladium
29665300 制造商:Eaton Corporation 功能描述:CONNECTOR ASSEMBLY 10 SHIELDED CABLE 制造商:Eaton Corporation 功能描述:SENSOR CABLE 10FT 制造商:Eaton Corporation 功能描述:SENSOR CABLE, 10FT; For Use With:Eaton Cutler Hammer Standard Duty Rotary Shaft Encoders; Cable Length:10ft; Connector Type A:Circular 6 Position Plug; Connector Type B:Free / Stripped End; Features:Includes Clamp and Bushing ;RoHS Compliant: Yes
2966537 功能描述:工业继电器 PLC-RSP-230UC/21 RoHS:否 制造商:TE Connectivity / Kilovac 触点形式:1 Form A (SPST-NO) 触点电流额定值: 线圈电压:9 VDC to 36 VDC 线圈电阻:38 Ohms 线圈电流: 切换电压: 安装风格:Panel 触点材料:Silver Palladium
2966540 功能描述:工业继电器 PLC-RSP- 24DC/21AU RoHS:否 制造商:TE Connectivity / Kilovac 触点形式:1 Form A (SPST-NO) 触点电流额定值: 线圈电压:9 VDC to 36 VDC 线圈电阻:38 Ohms 线圈电流: 切换电压: 安装风格:Panel 触点材料:Silver Palladium